Dialogic Brooktrout TR1034 DID, Combo, & Loop Start Manuale Utente Scaricare il pdf (Pagina 47)

Fax/Mail Servers Typical Deployment

Typically, the mail server used to transmit emails from users to XMediusFAX and the mail relay server used

to relay notifications from XMediusFAX to users can be the same mail server, as described in the following

schema:

Note: This example assumes that the receiving port number is 25 for both the XMediusFAX SMTP

Gateway and the mail server, which is usually the default port number for receiving emails.

Microsoft Exchange Integration

The Microsoft Exchange integration consists in allowing Exchange to support the sending of faxes and the

relaying of fax notifications.

First, it enables the support of:

• The FAX address space, that permits the use of Outlook fax contacts (to know how to enable this, see

Allowing Sending of Faxes with a FAX Address Space on page 37).

• The XMediusFAX Forms for Outlook, that allow users to send faxes and receive notifications through

custom forms especially designed for fax (To know how to publish these forms, see Microsoft Outlook

Forms on page 41).

Also, some configuration should be done on your Exchange server in order to enable the relaying of mail

notifications sent by the SMTP Gateway of XMediusFAX (see Allowing Reception of Mail Notification Messages

on page 40).

Allowing Sending of Faxes with a FAX Address Space

Note: Depending on your license, the XMediusFAX feature using a FAX address space to send faxes

from Outlook may be disabled. Please verify the terms of your license before performing the following

configuration.

To enable your Exchange Server to support the sending of faxes with a FAX address space, you just need

to create a new Exchange Connector having an address space of type FAX.

The procedure depends on your version of Exchange.

XMediusFAX | Installation and Maintenance Guide 37

Chapter 6 | SMTP Integration

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 101 102

Nessun commento

Dialogic Brooktrout TR1034 DID, Combo, & Loop Start Manuale Utente Pagina 47