Dialogic 2000 Series Manuale Utente

1 Dialogic® Media Gateway Installation and Configuration Integration Note 1. Scope This document is intended to detail a typical installation and

10 • Inbound VoIP Rules - When an outbound call comes in to the gateway from an IBM Lotus Sametime Unified Telephony Control Server, an Inbound VoIP

11 6.2 Important Gateway Trace Masks These keys are helpful during all troubleshooting scenarios and should be considered keys to activate by defaul

12 Copyright and Legal Notice Copyright © 2009 Dialogic Corporation. All Rights Reserved. You may not reproduce this document in whole or in part with

2 3. Prerequisites 3.1 PSTN Prerequisites The PSTN must support T1 (NI2, DMS100, or 5ESS) or E1 (ETSI EuroISDN). 3.1.2 PSTN Cabling Requirements

3 4.1.2 Connecting with Ethernet • Connect gateway to Network using LAN 1. • Configure computer connecting to the gateway on the 10.12.13.x subnet

4 • In the Config -> IP Settings page: o Set the BOOTP Enabled parameter to ‘No’ the (default is Yes) under the LAN1 settings block. LAN 2 can als

5 • In the VoIP -> General page: o Set the Transport Type to match IBM Lotus Sametime Unified Telephony requirements (the default is UDP). o Set

6 o If configuring each T1/E1 port on the gateway individually, please read on. Otherwise, skip to the next step. If each port on the gateway require

7 • In the VoIP -> Media page: o Set the Audio Compression parameter to match IBM Lotus Sametime Unified Telephony requirements (the default is G.

8 4.4.1 Media Gateway Connected to the PSTN • VoIP Host Group - The first item is to set up the IP address (IBM Lotus Sametime Unified Telephony Co

9 • Inbound TDM Rules - When an inbound call comes in to the gateway from the PSTN, an Inbound TDM rules need to be defined in order to route the cal